Vented case for 600mW Immersion RC Video Transmitter (411898)
Item Preview
There Is No Preview Available For This Item
This item does not appear to have any files that can be experienced on Archive.org.
Show all files
Wanted to encase the 600mw Immersion transmitter yet keeping it vented.
Here the design:
- Custom fit
- Vented yet sturdy printed also in PLA
- 3 mm air gap on the lower side, 5 mm on the upper side.
- Box is designed for the transmitter module face the much ventilated side.
- Once you put on the antenna, the transmitter card is fixed inside the box and auto-centered.
- Just add straps and fly!
Optimized for DJI installation, lower side, centered, near the battery (when I'll find time I'll upload some photos)
Here the design:
- Custom fit
- Vented yet sturdy printed also in PLA
- 3 mm air gap on the lower side, 5 mm on the upper side.
- Box is designed for the transmitter module face the much ventilated side.
- Once you put on the antenna, the transmitter card is fixed inside the box and auto-centered.
- Just add straps and fly!
Optimized for DJI installation, lower side, centered, near the battery (when I'll find time I'll upload some photos)
Reviews
There are no reviews yet. Be the first one to
write a review.
